# Updating VNET - Incorrect information in Conf tab

**URL:** https://forum.opennebula.io/t/updating-vnet-incorrect-information-in-conf-tab/1374
**Category:** Product Support
**Created:** [October 23, 2015, 4:44pm UTC](https://forum.opennebula.io/t/updating-vnet-incorrect-information-in-conf-tab/1374 "2015-10-23T16:44:03Z")
**Posts on this page:** 2
**Page:** 1

<div class="post-metadata">

### Author: ![michaudg](https://avatars.discourse-cdn.com/v4/letter/m/e9a140/32.png) [@michaudg](https://forum.opennebula.io/u/michaudg)
#### Post date: [October 23, 2015, 4:44pm UTC](https://forum.opennebula.io/t/updating-vnet-incorrect-information-in-conf-tab/1374/1 "2015-10-23T16:44:03Z")

</div>

With one-4.14.0, when updating an existing VNET, the Conf tab does not display the correct information about the Network model. For a ebtables VNET, “Default” is shown instead of “ebtables” and some VLAN options (VLAN ID, Physical device), not related to Default nor ebtables, are also shown. However, the information in the other tabs (General, Adresses, Security and Context) are correct.

Thank you.

---

<div class="post-metadata">

### Author: ![cmartin](https://yyz1.discourse-cdn.com/flex031/user_avatar/forum.opennebula.io/cmartin/32/4278_2.png) [@cmartin](https://forum.opennebula.io/u/cmartin)
#### Post date: [October 26, 2015, 10:02am UTC](https://forum.opennebula.io/t/updating-vnet-incorrect-information-in-conf-tab/1374/2 "2015-10-26T10:02:56Z")

</div>

Hi,

This is a consequence of the networking model implementation… The networking model is set for the host, but then you need to define the required attributes inside the vnet… So when a vnet is updated, the network model is not known (it is set in the host, not the vnet) and all the fields of the wizard are visible.