Installation on a single node

Community Support
1

Hello,
I’m planning to migrate my existing Proxmox VE environment to OpenNebula.

Reading the documentation I understand that I must perform(in this order)

  1. Front-end installation
  2. Node installation (preparing the hosts where the VMs are going to run)

Question:
How do I proceed if I have only a single node?

Actually I intended to run OpenNebula Front-end either in a VM or Container that is running on an OpenNebula Node.

Please advise.

THX

2

Hello, you simply run the node installation right after the frontend installation in the same node. If you want to check out how it works, please take a look at minione as it quickly deploys an all in one solution.